Specifications

• All fabrics will be inherently flame resistant. Flame certificates available upon request.
• Fullness to be a minimum of 10-15% in addition to cubicle curtain track length.
• Grommets are to be rust proof, nickel plated brass, set 6-1/2" on center.
• When a specific curtain width is required, cubicle curtains must be ordered as flat finished width. Cubicle curtains are manufactured to a length with a tolerance of plus or minus 1".Care and location labels are sewn into the reverse side of right hem, approximately 6" above bottom hem. Typically cubicle curtains finish 12" above floor.
• Mesh is to be open 1/2" on the diagonal.

• Hems are to be double folded, 1-1/8" and sewn with double needle lock stitch.
• Seams are to be double flap folded 1/2" and sewn with a double needle lock stitch.
• Curtain will finish at 4% less than specified size, due to allowance for hems and seams.

• Nylon mesh to have 1" non-woven tape inserted into fold as reinforcement and anchoring medium for the grommets.
• Sapor II mesh will finish at approximately 19-1/2".

• Cubicle curtains have a maximum finished length of 92".
• Cubicle curtains have 1-1/2" header containing grommets spaced 6-1/2" on center.
• Cubicle curtain fabric and mesh are knitted as one piece of fabric.
• 20" mesh typical, plus or minus 1" for industry tolerance. This method ensures the construction of a totally seamless cubicle curtain.
• Integral mesh cannot be shortened. Mesh must remain intact.
• Fabric is railroaded, so there are no vertical seams.